Watch Winder Review and Analysis - Part V

[ten10]

1) Have you taken a peek inside a watch winder to know how complicated it is? Or perhaps wished you could open yours without voiding your warranty just to know how it works?



2) Are you curious about what these electronic components do? How sure are you that your winder is a high-tech model? What assurance you have that your watches would not catch fire along with the winder?



If you’re curious about all these, then read PART V in the SG-ROC Diy Section…

[ten10]

I've done 3 main modifications to this winder...

a) Changed the AA-size battery holder to a D-size one; it now has a capacity of 36,000mAH instead of 2,700mAH and can last approx 3 months. (Forgot to take a photo)

b) Installed a Power LED

c) Designed a new POD to hold a single watch as well as two watches


This is the new winding POD. The right-side was also the same.




This is my own design. The middle cutout serves 2 functions:-
1) To place one watch when the other is in use. In old design, there'll be an unequal weight distribution causing motor gear failure.
2) To allow wide buckles to be inserted.

cheers!