Steel bracelet for Ball watches not comfortable, is there alternative bracelets?

[topaz]

Hi all,

I own a Ball Engineer Master II Chronometer with stainless steel bracelet.
However, when I put on the watch, I always got marks on my wrist as the
clasp of the bracelet had got a bit of a pointy edge. I didnt wore my watch
too tight nor loose and if anyone had this watch, or ball watch with steel
bracelet, you will know what I mean. This does hurt a bit and is uncomfortable.

So my question is, I would like to change the bracelet to a more comfortable
one. If ball had bracelets that had clasps that is different from the one on
this watch, please let me know. Else is there any other steel bracelets that
can fit the width of the lug?

Thanks in advance.

[TanWL]

I find this very comfortable .

[exxondus]

My old engineer master chronometer's bracelet was one of the most comfortable ever. On the other hand, the EM II Diver Chronometer that I used to have did have a pretty sharp clasp and from time to time, would pluck at my wrist hair

[topaz]

I find this very comfortable .

Which watch is this bracelet from? Will it fit my emII chrono?

[sys12345]

Did u take a close look at your bracelet, especially the areas that are scratching your wrist? I find that Ball bracelets are one of the most comfortable and there's no hair pulling experience with them. If your bracelet is properly sized, the clasp should not be causing discomfort to you. I suspect there are some rough edges that are not properly finish. U might like to bring the watch back to Ball Singapore and get them to look into it.

[TanWL]

Which watch is this bracelet from? Will it fit my emII chrono?

Its from Ionosphere, lug size 21mm.